Re: [Paparazzi-devel] GPS receiver GS407

[Rolf Nöllenburg]

Hi

My 407 arrived and shows the same behaviour: connects fine with ucenter, 
doesn't keep changes.
I tried to connect an additional backup-battery which helps to keep the 
settings but this is not my prefered solution for this issue.


-------- Original-Nachricht --------
> Datum: Sat, 2 Feb 2013 08:43:54 +0100
> Von: Steffen Spies <address@hidden>
> An: "address@hidden" <address@hidden>
> Betreff: Re: [Paparazzi-devel] GPS receiver GS407

> I have this GPS which has a uBlox6 chip and it shows very similar
> behavior.
> https://www.sparkfun.com/products/9566?
> 
> No problem to connect to it via ucenter, but it doesn't keep the changes
> after a powercycle.
> 
> Steffen
> 
> Am 01.02.2013 um 22:42 schrieb Tobias <address@hidden>:
> 
> > 
> > sounds promising :-) 
> > 
> > I had the gps connected to u-center via the serial port (ftdi board) and
> full acces. 
> > The default baudrate that is restored after disconnecting the power is
> 9600. connected the GPS to the autopilot (twog) gives the mentioned debug
> message. looking through the code I dont see an option where a random
> hardware or software version is crated - so I m pretty sure that part is 
> already
> working. 
> > Would be really nice if you could lend me a hand to fix this ...
> > 
> > Tobi
> > _______________________________________________
> > Paparazzi-devel mailing list
> > address@hidden
> > https://lists.nongnu.org/mailman/listinfo/paparazzi-devel