Thanks for the tip on connecting via the P-Active arc, that seems to work. I'll have to experiment a bit more to see if I can get rid of other errors of this type. There are a lot of overlap and touching errors in the padframe I downloaded from Mosis but I don't think there's anything I can do about that (beyond re-laying out the pads).
Hello Pierce,
Try to connect port of P-transistor and Metal1-P
Active contact by
a short P-Active arc.
If nodes are not connected by arc, Electric doesn't
know that you want them to be connected,
and it thinks that you overlapped them accidently.
-Dima
Hello,
Is there a way
to stop designated DRC errors? For example, when a Metal1-P Active connector is placed on a P transistor active region, a DRC error is generated:
DRC error 4 of 7: Spacing (layer P-Active): node Metal-1-P-Active-Con OVERLAPS arc P-Active [rule 2.2]
However I am merely connecting the transistor drain, so I would like to suppress this error.
Other times like layers might be intended to touch and a DRC error is correctly generated. However, I would often like to selectively suppress these errors as well. Is there a way to do this?
Thanks very much,
Pierce
Ahhh...imagining that irresistible "new car" smell?
Check out
new cars at Yahoo! Autos. _______________________________________________
Bug-gnu-electric mailing list
address@hidden
http://lists.gnu.org/mailman/listinfo/bug-gnu-electric
Ahhh...imagining that irresistible "new car" smell?
Check out
new cars at Yahoo! Autos.