[Paparazzi-devel] Eagletree airspeed sensor problems

[Chris]

Hi.
I am sure this has come up in the past but i can't locate the thread so 
i must ask again.
When i connect the Eagletree airspeed sensor V3 on a lisa m2 the I2C bus 
freezes.
The only other device on the bus is the ppzimu, the wiring is fine and 
the airspeed sensor's display shows
the highest measurement as it should.
Without the airspeed sensor everything works fine.
Btw i have tried with a startup delay and with out it but there is no 
change.
Any ideas of what i am doing wrong?
(I think i will go with the analog version of the airspeed sensor)
Thanks
Chris