Re: Mingw Octave 3.4.2 - blank gnuplot printouts

[Tatsuro MATSUOKA]

Hello

Using octave built from development source, all prints went without failure.
Hmmm

Anyway I will look into in detail.

Regards

Tatsuro

--- On Sat, 2011/9/10, Tatsuro MATSUOKA  wrote:

> Hello
> 
> With your package and my current packages
> 
> graphics_toolkit gnuplot
> peaks
> print -demf peaks.emf
> print -dpng peaks.png
> print -deps peaks.eps
> print -dps peaks.ps
> print -dsvg peaks.svg
> print -djpg peaks.jpg
> 
> Success, emf and svg.
> Failure png, eps, ps and jpg
> 
> I have not tried the other formats.
> 
> Hmm.  I have not make enough explanation why current build fails in print 
> command in some formats..
> 
> I have further look into this phenomena.
> 
> Regards
> 
> Tatsuro.
> 
> --- On Fri, 2011/9/9, Nit Nit wrote:
> 
> > 
> > Hello Tatsuro and other octave maintainers,
> > 
> > With your mingw build of octave-3.4.2 + gnuplot when using 
> > graphics_toolkit('gnuplot') - printing a figure (with 'print') always 
> > produce a blank page.
> > This happens with my installation tree (as can be downloaded with mingw 
> > octave 3.4.2 links in your wiki 
> > http://wiki.octave.org/wiki.pl?OctaveForWindows).
> > 
> > For graphics_toolkit('fltk') printing is ok !
> > 
> > With previous mingw build of octave 3.2.4 with graphics_toolkit('gnuplot'), 
> > printed figures are ok.
> > 
> > Are you also facing this problem ? Do you have any idea what may cause it ?
> > 
> > Regards,
> > 
> > Nitzan
>