Re: arm cross compiled monit segv

[Martin Pala]

We try to make the pre-compiled binary as universal as possible, so there can be one build which runs on many platforms. If optimized binary is necessary, it is better to build it from the source code.

On 10 Oct 2015, at 13:04, admin-at-extremeshok-dot-com <address@hidden> wrote:

Please compile an ARMv7 for pi2's, which is also better for most newer arm devices. (excludes the latest ARMv8 / AARch64 devices.)

ARMv6 needs to be complied with Hard Float support to benefit the rpi1 hardware.

__________________________________.    https://eXtremeSHOK.com     .__________________________________

On 10-Oct-15 12:56 PM, Martin Pala wrote:

It is compile on Raspberry Pi 1 (ARMv6), should run on newer ARM architectures too (we test the same binary runs on Raspberry Pi 2 too)

On 10 Oct 2015, at 12:52, address@hidden wrote:

This is compiled for which arm exactly ?

Sent from my iPhone

On 10 Oct 2015, at 12:32 PM, Martin Pala <address@hidden> wrote:

Please can you test the pre-compiled binary: https://mmonit.com/monit/dist/binary/5.14/monit-5.14-linux-arm.tar.gz

Regards,
Martin

On 09 Oct 2015, at 17:50, Terry Duncan <address@hidden> wrote:

I have cross-compiled monit 5.13 for ARM and have it running on my ARM system. When it hits an exception, I get a SEGV in the longjmp call. Has anyone seen this problem and have a solution or suggestion?

Thanks
--
To unsubscribe:
https://lists.nongnu.org/mailman/listinfo/monit-general

--
To unsubscribe:
https://lists.nongnu.org/mailman/listinfo/monit-general

--
To unsubscribe:
https://lists.nongnu.org/mailman/listinfo/monit-general

--
To unsubscribe:
https://lists.nongnu.org/mailman/listinfo/monit-general

--
To unsubscribe:
https://lists.nongnu.org/mailman/listinfo/monit-general