Re: arm cross compiled monit segv

[admin-at-extremeshok-dot-com]

Please compile an ARMv7 for pi2's, which is also better for most newer arm devices. (excludes the latest ARMv8 / AARch64 devices.)

ARMv6 needs to be complied with Hard Float support to benefit the rpi1 hardware.

__________________________________.    https://eXtremeSHOK.com     .__________________________________

On 10-Oct-15 12:56 PM, Martin Pala wrote:

It is compile on Raspberry Pi 1 (ARMv6), should run on newer ARM architectures too (we test the same binary runs on Raspberry Pi 2 too)

On 10 Oct 2015, at 12:52, address@hidden wrote:

This is compiled for which arm exactly ?

Sent from my iPhone

On 10 Oct 2015, at 12:32 PM, Martin Pala <address@hidden> wrote:

Please can you test the pre-compiled binary: https://mmonit.com/monit/dist/binary/5.14/monit-5.14-linux-arm.tar.gz

Regards,
Martin

On 09 Oct 2015, at 17:50, Terry Duncan <address@hidden> wrote:

I have cross-compiled monit 5.13 for ARM and have it running on my ARM system. When it hits an exception, I get a SEGV in the longjmp call. Has anyone seen this problem and have a solution or suggestion?

Thanks
--
To unsubscribe:
https://lists.nongnu.org/mailman/listinfo/monit-general

--
To unsubscribe:
https://lists.nongnu.org/mailman/listinfo/monit-general

--
To unsubscribe:
https://lists.nongnu.org/mailman/listinfo/monit-general

--
To unsubscribe:
https://lists.nongnu.org/mailman/listinfo/monit-general