Re: [Lynx-dev] reading code section

[Tom Masterson]

My appologies to all.  It appears it is showing the code sections 
correctly.  It is a section from a book and the way it is written it makes 
it look like you are missing things.  Such as use the following command to 
run this program and then it has multiple blank lines (3 to 4) and then a 
command that is not actually shown as a console command i.e no prompt 
shown so it looks like it is the answer to the run code not the command to 
run it.  Maybe ok visually but a bit confusing when using braille.

Tom


On Sat, 21 Nov 2020, Halaasz Saandor via Lynx-dev wrote:

> 2020/11/21 12:11 ... Tom Masterson:
> > This is al a good discussion but it does not answer my question.  For 
> > some pages I can modify the html and make it readable, however there a 
> > number of sites out in the wild that use the <code>...</code> to show 
> > coding.  I would like to be able to read that code without having to 
> > download and reformat the pages.  So is it possible to have lynx read 
> > those segments or do I need to modify lynx itself?
>
> What webpage?
> I try something bracketed by <code>...</code> and with no trouble 
> clearly see it in Lynx. Furthermore, I tryed also an unknown entity and 
> found that Lynx simply ignored that. Therefore, in your case it is not 
> ignored, but turned into something else. If it were <script>, I would 
> expect it to disappear.
>
> _______________________________________________
> Lynx-dev mailing list
> Lynx-dev@nongnu.org
> https://lists.nongnu.org/mailman/listinfo/lynx-dev