Re: Octave for Mac with Reference Lapack

[Lukas Reichlin]

On 29.05.2012, at 20:05, c. wrote:

> 
> On 29 May 2012, at 19:07, Lukas Reichlin wrote:
> 
>> 
>> and install that package. Then try
>> 
>>      test moen4
>> 
>> IIRC it passes with Accelerate from 10.6.8.
> 
> YRC:
> 
>>> test moen4
> PASSES 9 out of 9 tests
> 
> 
> 
>> Next, try one of the unpolished examples from the DaISy library in the devel 
>> subfolder (it is not included when you use pkg install), for example
>> 
>>      PowerPlant
>>      DestillationME
>> The plots of the measurements and simulation should match reasonably well,
> 
> The plots are attached, would you say they "match well"?
>> i.e.
>> variable "err" should be < 1
> 
> PowerPlant:
> err =  0.22350
> 
> DestillationME:
> err = 0.13644 
> 
> is that small enough?
> 
> I do see a different problem though: each example can be runned only once, if 
> I run it again I get:
> 
> ...
> err =  0.22350
> st =  1
> warning: broken pipe -- some output may be lost
> warning: broken pipe -- some output may be lost
> warning: broken pipe -- some output may be lost
> warning: broken pipe -- some output may be lost
> warning: broken pipe -- some output may be lost
> warning: broken pipe -- some output may be lost
> warning: broken pipe -- some output may be lost
> 
> and Octave hangs.
> 
>> Lukas
> c.

Oops, Sorry, of course you are getting perfect results: octave-devel also 
includes the reference lapack :-) See the Makefile in the "src" subfolder.

Lukas