Re: [Therion] 3D models

[Wolfgang Zillig]

>  
>
>>So this is possible not the best way to do it, but it seems that I
>>missed the correct way of doing it in the manual. So I will read the
>>manual again.
>>    
>>
>
>In therion it is done following way (example):
>
># surface command for entering surface
>surface
># grid to specify position of surface
># grid X-start Y-start X-step Y-step C-columns R-rows
>  grid 400080 5419750 10 10 190 68
># calibrated surface texture - not yet supported in 3D viewer
>  bitmap <filename> [calibration-parameters]
># followed by CxR altitudes matrix
>  1520 1530 ...
>  ...
>  1680 1690 ...
>endsurface
>  
>
Life could be so simple ;-)

Wolfgang
_______________________________________________
Therion mailing list
address@hidden
http://www.speleo.cz/mailman/listinfo/therion