If GICD_CTLR_DS bit is zero and the NMI is non-secure, the NMI prioirty
is higher than 0x80, otherwise it is higher than 0x0. And save NMI
super prioirty information in hppi.superprio to deliver NMI exception.
Since both GICR and GICD can deliver NMI, it is both necessary to check
whether the pending irq is NMI in gicv3_redist_update_noirqset and
gicv3_update_noirqset. And In irqbetter(), only a non-NMI with the same
priority and a smaller interrupt number can be preempted but not NMI.
Signed-off-by: Jinjie Ruan<ruanjinjie@huawei.com>
---
v7:
- Reorder the irqbetter() code for clarity.
- Eliminate the has_superprio local variable for gicv3_get_priority().
- false -> cs->hpplpi.superprio in gicv3_redist_update_noirqset().
- 0x0 -> false in arm_gicv3_common_reset_hold().
- Clear superprio in several places for hppi, hpplpi and hppvlpi.
v6:
- Put the "extract superprio info" logic into gicv3_get_priority().
- Update the comment in irqbetter().
- Reset the cs->hppi.superprio to 0x0.
- Set hppi.superprio to false for LPI.
v4:
- Replace is_nmi with has_superprio to not a mix NMI and superpriority.
- Update the comment in irqbetter().
- Extract gicv3_get_priority() to avoid code repeat.
---