[PATCH] hw:w25p80: Add STATE_STANDBY to handle incorrect command

[Dan Zhang]

---
 hw/block/m25p80.c | 7 +++++++
 1 file changed, 7 insertions(+)

diff --git a/hw/block/m25p80.c b/hw/block/m25p80.c
index b6bd430a99..3bb0466dca 100644
--- a/hw/block/m25p80.c
+++ b/hw/block/m25p80.c
@@ -423,6 +423,7 @@ typedef enum {
     STATE_COLLECTING_DATA,
     STATE_COLLECTING_VAR_LEN_DATA,
     STATE_READING_DATA,
+    STATE_STANDBY,
 } CMDState;
 
 typedef enum {
@@ -1218,6 +1219,9 @@ static void decode_new_cmd(Flash *s, uint32_t value)
             || !s->write_enable) {
             qemu_log_mask(LOG_GUEST_ERROR,
                           "M25P80: Status register write is disabled!\n");
+           qemu_log_mask(LOG_GUEST_ERROR,
+                          "M25P80: switch to standby, re-aseert CS to 
reactivate \n");
+           s->state = STATE_STANDBY;
             break;
         }
 
@@ -1472,6 +1476,9 @@ static uint32_t m25p80_transfer8(SSIPeripheral *ss, 
uint32_t tx)
                           s->cur_addr, (uint8_t)tx);
 
     switch (s->state) {
+    case STATE_STANDBY:
+       r = 0xFFFFFFFF; /* StandBy state SO shall be HiZ */
+       break;
 
     case STATE_PAGE_PROGRAM:
         trace_m25p80_page_program(s, s->cur_addr, (uint8_t)tx);
-- 
2.34.3