Re: [Paparazzi-devel] GPS not working

[Romney, Jefferson S]

Jaime, I have had a few of the same problems with my yapa and GPS. for GPS, i would check your baud rate and make sure the correct subsystem is loaded. what type of GPS are you using?  as for the RC, I would check your PPM and make sure that is changing like it should. an o-scope is probably the easiest way to do that. if the PPM signal is changing correctly check your RC file and make sure everything is in the proper order.

---

From: paparazzi-devel-bounces+address@hidden [paparazzi-devel-bounces+address@hidden on behalf of Jaime Rubio address@hidden
Sent: Monday, April 02, 2012 9:32 PM
To: address@hidden
Subject: [Paparazzi-devel] GPS not working

Hello,

Trying to get my RC working I have noticed that I cannot switch modes. Once I open the ground control station, it always stays as auto 2. I think this may be related to the fact that it doesn't identify any GPS signal and it works in a kind of failsafe mode automatically, can this be the reason? There is also an error in the Paparazzi Center saying "Unix.Unix_error(2, "read", "")". How can I get my GPS working? I have configured it with U-center and everything is ok, however, it never works when connected to Yapa.

Thanks,

--

Jaime Rubio

Autopilot Team Lead

Phone: 386-383-2738

e-mail: address@hidden