[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Monit Cross Compile - v5.3.2
From: |
Martin Pala |
Subject: |
Re: Monit Cross Compile - v5.3.2 |
Date: |
Thu, 8 Mar 2012 16:34:28 +0100 |
We cross-compile for PPC on MacOSX with Roseta installed … it allows to run the
configure's test programs compiled for ppc on x86 architecture.
Regards,
Martin
On Mar 7, 2012, at 8:17 PM, Mike J wrote:
> I'm trying to get monit cross compiled for a PPC arch.
> The configure command I use is:
>
> ./configure --without-ssl --without-pam --prefix=/whatever
> --host=powerpc-linux --mandir=/whatever/docs
>
> CC is setup in the makefiles that I'm using.
>
> Configure dies with the following message:
> -------------------------------------
> configure: error: in `/tmp/monit-5.3.2/libmonit':
> configure: error: cannot run test program while cross compiling
> See `config.log' for more details.
> configure: error: ./configure failed for libmonit
> make: *** [configuration] Error 1
> -------------------------------------
> config.log doesn't have anything obvious that I can see. The last few lines
> are:
>
> -------------------------------------
> 8778 sbindir='${exec_prefix}/sbin'
> 8779 sharedstatedir='${prefix}/com'
> 8780 sslincldir=''
> 8781 ssllibdir=''
> 8782 subdirs=' libmonit'
> 8783 sysconfdir='${prefix}/etc'
> 8784 target_alias=''
> 8785
> 8786 configure: exit 1
> -------------------------------------
>
> Does anybody have any ideas why config is dying on libmonit?
>
> Thanks.
> --
> To unsubscribe:
> https://lists.nongnu.org/mailman/listinfo/monit-general