I downloaded from OCTAVEFORGE the package "gnuplot-1.0.x"
because I need to be able to zoom into my plots.
( with the basic plot command I cannot do that -octave 3.2.4 ).
I setup the package with the usual
pkg install gnuplot.tar.gz
But commands like g_ez is not available.
If I go in the folder where the package is installed g_ez is recognized
and it works pretty well..so my guess is that octave is not able to include this package
properly or refer to its folder.
Do you know what could be a starting point to solve this issue?
Any commands or config file or also notes relted these kind of settings?
Thanks in advance
CS