On 6/30/2012 19:15, Tomalak Geret'kal wrote:
On 01/07/2012 02:44, Alexander Carver wrote:
Skyview is good. During the insertion I had seven
satellites locked.
Currently I have six locked with four more too far down
on the horizon
to lock. Signals were good ranging from 35-45 db-Hz.
HDOP has been
holding below 2.0 and the overall wander has been steady
inside a 10
meter circle. I also have the SBAS satellite in view
and locked.
Overall, it shouldn't have had an issue getting the
offset message.
It's currently still reporting 15 seconds offset.
Peculiar!
Very much. I went ahead and performed another cold start
and forced it to dump the contents of the SRAM and the RTC
but that hasn't helped either. It still picked up on a 15
second offset instead of a 16 second offset (technically
it's showing 14.999999998 seconds right now).
I'm a bit annoyed because I was using this receiver for
time keeping (ntpd) and I also have half a dozen more of
them (got them for free). They all work(ed) fine but now
has my NTP server very confused because the time is
reported to be one second behind the real time.
I can't figure out if there's a way to reset the offset in
NVRAM so that it reports properly.