Re: [Discuss-gnuradio] Simulation to compute BER of a Modulator/Demodulator Encoding/Decoding system

[Cinaed Simson]

On 10/22/2018 01:10 PM, Christian BusquielSanz wrote:
> On Sat, 20 Oct 2018 at 08:00, Cinaed Simson <address@hidden> wrote:
>> Maybe you removed the Delay slider? The default value is 0 - try setting
>> it to 2 in the Qt GUI Range.
>>
>> -- Cinaed
> 
> No, I did not remove the slider (It shows in the picture that the
> slider is there, on top)
> 
> I changed the default value to 2, because that is how it synchronizes
> in my computer
> 
> I was just pointing out that the BER does not plot straight away if
> the default value is different from 0
> If the delay value is set to 0, it starts plotting it right away
> If it is different than 0, I need to click on the slide or click the
> arrows to change the value so it starts plotting,
> then click again to switch it back to 2 so the two signals are synchronized

Sorry, I didn't look at the image.

> 
> I am using Ubuntu 18.04 in Oracle VM Virtual Box in a Windows 10 Pro
> 64 bit operating system, in case that the issue comes from there
> 

Ah, that's most likely the issue. I'm running Debian on bare metal with
an i7 and I don't have any problems.

-- Cinaed