|
From: | Rogers Colin M |
Subject: | Screen stops attached process in copy mode |
Date: | Fri, 30 Jun 2006 12:10:58 +0100 |
I'm running a program in that produces significant
amounts of terminal output. I start this program in a detached screen, and at
some point later attach it. This presents me with a view of the output from the
program, which is fine. However, if I then enter copy mode, a short while later the
program stops execution, and only resumes when I leave copy mode. This is very
irritating as the program is time dependent, and so stopping it running causes
problems. I can't find anything about this in the manual, so can
anyone tell me if this is the intended behaviour, and whether I can get around
it in anyway (i.e. allow the program to keep outputting to the "terminal"
when in copy mode?) TIA The information contained in this E-Mail and any
subsequent For those other than the recipient any disclosure,
copying, Emails and other electronic communication with
QinetiQ may be monitored Telephone calls to QinetiQ may be monitored or
recorded for quality |
[Prev in Thread] | Current Thread | [Next in Thread] |