[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [PATCH v4 29/57] tcg/s390x: Use full load/store helpers in user-only
|
From: |
Peter Maydell |
|
Subject: |
Re: [PATCH v4 29/57] tcg/s390x: Use full load/store helpers in user-only mode |
|
Date: |
Fri, 5 May 2023 13:16:13 +0100 |
On Wed, 3 May 2023 at 08:29, Richard Henderson
<richard.henderson@linaro.org> wrote:
>
> Instead of using helper_unaligned_{ld,st}, use the full load/store helpers.
> This will allow the fast path to increase alignment to implement atomicity
> while not immediately raising an alignment exception.
>
> Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
> ---
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
thanks
-- PMM
- [PATCH v4 24/57] tcg/loongarch64: Use full load/store helpers in user-only mode, (continued)
- [PATCH v4 24/57] tcg/loongarch64: Use full load/store helpers in user-only mode, Richard Henderson, 2023/05/03
- [PATCH v4 25/57] tcg/riscv: Use full load/store helpers in user-only mode, Richard Henderson, 2023/05/03
- [PATCH v4 26/57] tcg/arm: Adjust constraints on qemu_ld/st, Richard Henderson, 2023/05/03
- [PATCH v4 27/57] tcg/arm: Use full load/store helpers in user-only mode, Richard Henderson, 2023/05/03
- [PATCH v4 29/57] tcg/s390x: Use full load/store helpers in user-only mode, Richard Henderson, 2023/05/03
- Re: [PATCH v4 29/57] tcg/s390x: Use full load/store helpers in user-only mode,
Peter Maydell <=
- [PATCH v4 28/57] tcg/mips: Use full load/store helpers in user-only mode, Richard Henderson, 2023/05/03
- [PATCH v4 31/57] tcg/sparc64: Rename tcg_out_movi_imm13 to tcg_out_movi_s13, Richard Henderson, 2023/05/03
- [PATCH v4 30/57] tcg/sparc64: Allocate %g2 as a third temporary, Richard Henderson, 2023/05/03
[PATCH v4 32/57] tcg/sparc64: Rename tcg_out_movi_imm32 to tcg_out_movi_u32, Richard Henderson, 2023/05/03