qemu-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Qemu-devel] [qemu-s390x] [PATCH-for-4.2 v1 1/6] s390x/mmu: ASC sele


From: Thomas Huth
Subject: Re: [Qemu-devel] [qemu-s390x] [PATCH-for-4.2 v1 1/6] s390x/mmu: ASC selection in s390_cpu_get_phys_page_debug()
Date: Mon, 12 Aug 2019 18:04:30 +0200
User-agent: Mozilla/5.0 (X11; Linux x86_64; rv:60.0) Gecko/20100101 Thunderbird/60.8.0

On 8/12/19 5:39 PM, David Hildenbrand wrote:
> On 12.08.19 17:28, David Hildenbrand wrote:
>> On 12.08.19 17:18, Thomas Huth wrote:
>>> On 8/12/19 1:27 PM, David Hildenbrand wrote:
>>>> Let's select the ASC before calling the function. This is a prepararion
>>>> to remove the ASC magic depending on the access mode from mmu_translate.
>>>>
>>>> There is currently no way to distinguish if we have code or data access.
>>>> For now, we were using code access, because especially when debugging with
>>>> the gdbstub, we want to read and disassemble what we single-step.
>>>
>>> IMHO we should add a "instruction" bit to MemTxAttrs and then use the
>>> ...page_attrs_debug() interface instead. But ok, that's likely really
>>> something for a separate clean-up, so for the time being:
>>>
>>
>> That sounds like a good idea, and then switching over to
>> cc->get_phys_page_attrs()
> 
> But looking at get_phys_page_attrs_debug() again, "MemTxAttrs *attrs" is
> an output value not an input value. So there wouldn't be a way to
> specify "what you want" from the caller. At least unless I am missing
> something :)

Oops, you're right. Too bad :-(

So never mind that idea ... your patch is certainly the best you can do
here right now.

 Thomas




reply via email to

[Prev in Thread] Current Thread [Next in Thread]