Re: [Paparazzi-devel] powering lisa/m v2

[Bruzzlee]

hi oswald

At first I my wiring was like this:
http://wiki.paparazziuav.org/wiki/File:LisaMWiring_Quadrotor.png
(only one ESC connected)

But now I'm using a UBEC like Piotr already told you.
Because the ESC was getting too hot for some reason....

Bruzzlee

On 01.06.14 23:33, Oswald Berthold wrote:
> hi all again,
>
> a question about powering lisa/m v2. if powering via the servo 5V rail,
> it is suggested in [1] to connect all (e.g. 4) servos (ESCs) to
> signal/5V/gnd. isn't that supposed to induce differential lateral
> currents among the individual BECs or is that somehow prevented?
>
> i was anyway powering from only one ESC, which seemed insufficient for
> all of lisa and the periphery. i think i've seen some weird IMU outages
> due to this, the ESC got quite hot too. now using a separate UBEC.
>
> bst, oswald
>
>
> [1] 
> http://wiki.paparazziuav.org/wiki/Lisa/M_v2.0#Quadrocopter.2C_Spektrum_Satellite_Receivers_and_PWM_Motor_Controllers_.28ESC.29
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel