paparazzi-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] can't arm the motors


From: evan igor
Subject: Re: [Paparazzi-devel] can't arm the motors
Date: Thu, 6 Mar 2014 23:18:59 +0200

I made the trim for the all throttle , yaw,pitch and roll but there is no reaction on motors :(

and add to the airframe the UART i'm using but also no reaction


On Thu, Mar 6, 2014 at 11:15 PM, AFISH <address@hidden> wrote:
Try to low throttle, maybe you need trim to the lowest position.

Sent from Mailbox for iPhone


On Thu, Mar 6, 2014 at 4:11 PM, evan igor <address@hidden> wrote:

Hi everyone in this great community,

i got paparazzi lisa/m and i connected the spectrum satellite receiver to UART 1/5.
connect the v_in to 5 volt from speed controller and its GND to the GND of speed controller and connect simply one motor for testing after powering it from external lipo 6 cell. make the binding procedure then make the transmitter in the position low throttle full yaw.  


but 
<B04.gif>
 no action to the motor.

any advices.

thanks


_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel



reply via email to

[Prev in Thread] Current Thread [Next in Thread]