Re: [Paparazzi-devel] no response for any of the motors

[Sergey Krukowski]

Hi!

First of all check your servo power voltage. If yes - try to check if  
there an output signal on servo pin.
As a second, do you have a telemetry connection from Lisa to GCS? In other  
words - is the board work at all?

Best Regards,
Sergey

> Hi everyone;
>
> i have paparazzi lisa/m i connected with it receiver spectrum, it's the
> first time for me to use paparazzi as i trying to develop autopilot  
> system
> using arduino intel adn i intend to use paparazzi algorithms with refer  
> to
> it in my work, now i'm trying to fly with it to make comparison with
> paparazzi in flight response.
>
> 1- now i connect v_in to 5 volt of speed controller and GND to GND of  
> speed
> controller.
> 2- connect the GPS neo_6m to the UART 3.
> 3- connect spectrum receiver to UART1/5.
>
> connect a servo as test to one of the output of liza/m and after making
> binding while GND the ADC1 in ANALOG1.
>
> upload firmware to the liza/m from the CGS for the quadrotor.
>
> but no response in the servo even any power.
>
> thanks and hope for help.


--
Erstellt mit Operas revolutionärem E-Mail-Modul: http://www.opera.com/mail/