Re: [Paparazzi-devel] YAPA2 First Time

[Christophe De Wagter]

If you are using xbee's, this behavior has been reported before when the adresses do not match. Are you using xbee-api mode or transparent? 

If it would be any hardware related issue, then it is a power-supply problem. So how did you power your board? Can you measure the 5V output of thee  switching regulator and 3.3V for the processor?

-Christophe 

On Tue, Jul 16, 2013 at 12:39 AM, GalapagosUAV <address@hidden> wrote:

Hello all,


I am trying put to work another new YAPA2 that I have and it is giving me some trouble. The status LED3 (green) blinks for a second and then it stops and I get on the mode section of the GCS a FAIL status. I wonder if there is anything else I that I need to do to this new YAPA2 board before put it to work or it is just damaged?


Best Regards,
Jorge



_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel