On Sat, May 5, 2012 at 8:01 PM, Cedric Marzer
<address@hidden> wrote:
Hello Martin,
I succeeded to make the logomatic log thanks to your code, but when I try to use sd2log I get the following error : pprz.values_of_payload too many bytes…
I must admit that I haven't soldered the capacitor you mentioned. I might try that tonight but I doubt that it is the problem…
Did you make a change to the code that is not reflected to the github ?
I also noticed that the logomatic code is only in the dev branch (and this is not mentioned in the wiki).
Thank you for your help.
Cédric
Le 11 mars 2012 à 15:25, Martin Mueller a écrit :
> Hi Cédric,
>
> have added support for the Logomatic on the dev branch. Some general fixes for the logger were also needed.
>
> Had not seen that Sparkfun board. Looks interesting, maybe a little too huge (only a few millimeters shorter than the Tiny). Had to add at least a large capacitor to the LiPo port to make it work. Otherwise the charge circuit kept the Vcc oscillating too much.
>
> Needs some changed routing to make use of the LiPo together with an autopilot (USB Vbus <-> 5V from autopilot).
>
> Martin