Re: [Paparazzi-devel] PPM encoder not transmitting power to the receiver

[Reto Büttner]

If you are using the ATmega PPM Encoder Board you need the JR1 Jumper in place to power the receiver:

http://paparazzi.enac.fr/w/images/Servo2ppm_manual_v4_2.pdf

Cheers, Reto

Am 2. April 2012 05:34 schrieb Luiz Flavio Felizardo <address@hidden>:

No worries glad to help.

On Sun, Apr 1, 2012 at 10:05 PM, Jaime Rubio <address@hidden> wrote:

Thanks, it worked!

On Sun, Apr 1, 2012 at 8:10 PM, Luiz Flavio Felizardo <address@hidden> wrote:

I had the same problem, my solution was to get the energy needed on the receiver from a servo.

so the 5v and GND directly from a servo input to the receiver battery slot.

On Sun, Apr 1, 2012 at 8:46 PM, Jaime Rubio <address@hidden> wrote:

Hello,

I am integrating the RC into my hardware and I am having the following problem: The connections between the autopilot (Yapa) and the PPM encoder work ok, but not so with the receiver. When the autopilot is powered, the PPM encoder gets that power but it is not transmitted to the receiver (i.e. multimeter reads zero voltage coming out from the output voltage pins from the PPM to the receiver).

Could anybody give us any hint to fix this?

Thanks,

--

Jaime Rubio

Autopilot Team Lead

Phone: 386-383-2738

e-mail: address@hidden

 

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

--

Jaime Rubio

Autopilot Team Lead

Phone: 386-383-2738

e-mail: address@hidden

 

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel