paparazzi-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] PPM encoder not transmitting power to the receiver


From: Jaime Rubio
Subject: Re: [Paparazzi-devel] PPM encoder not transmitting power to the receiver
Date: Sun, 1 Apr 2012 21:05:14 -0400

Thanks, it worked!

On Sun, Apr 1, 2012 at 8:10 PM, Luiz Flavio Felizardo <address@hidden> wrote:
I had the same problem, my solution was to get the energy needed on the receiver from a servo.
so the 5v and GND directly from a servo input to the receiver battery slot.

On Sun, Apr 1, 2012 at 8:46 PM, Jaime Rubio <address@hidden> wrote:
Hello,

I am integrating the RC into my hardware and I am having the following problem: The connections between the autopilot (Yapa) and the PPM encoder work ok, but not so with the receiver. When the autopilot is powered, the PPM encoder gets that power but it is not transmitted to the receiver (i.e. multimeter reads zero voltage coming out from the output voltage pins from the PPM to the receiver).

Could anybody give us any hint to fix this?

Thanks,

--
Jaime Rubio
Autopilot Team Lead
 


_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel



_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel




--
Jaime Rubio
Autopilot Team Lead
Phone: 386-383-2738
e-mail: address@hidden
 


reply via email to

[Prev in Thread] Current Thread [Next in Thread]