Hello,I have a couple of questions:1) I know that for Yapa2, I can write the airframe configuration file with either twog or tiny as board. Is there any difference between writing any of them?2) I want to power externally the servos. I know that it is possible but I don't find a clear procedure. Given my little experience with batteries and the fact that I already burned a Yapa, I would like to clearly know which procedure to follow. Any 5V battery would be fine? Where should I connect it? I don't want to brigde the Yapa for this since I have read is not too recommendable. I use Futaba S3305. Details of these servos can be found below. Futaba also states: "Per Futaba this servo is approved for use with NiCd batteries ONLY! This servo can produce high-current draw from your batteries. If using NiMH or LiPo batteries, make sure they are capable of delivering sufficient amps."
Volts
Torque
Speed
4.8V
99 oz-in (7.1 kg/cm)
0.25 sec/60°
6.0V
124 oz-in (8.9 kg/cm)
0.20 sec/60°
Dimensions
Weight
1-9/16 x 13/16 x 1-1/2 in (40 x 20 x 38 mm)
1-11/16 oz (47 g)
Thanks,Jaime.
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel