[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Radio not working after migration to current versi

From: Felix Ruess
Subject: Re: [Paparazzi-devel] Radio not working after migration to current version - How to activate PPM Messages
Date: Tue, 28 Dec 2010 15:52:57 +0100

Hi Tim,

you updated your airframe file to the subsystems?
You can still activate the ppm message just like before and like it says on the wiki ( ) by adding
  <define name="TELEMETRY_MODE_FBW" value="1"/>
to the firmware section in your airframe file.

What changed and I guess is your problem is that now the ppm signal is better checked for validity and the number of channels has to match _exactly_ to be a valid signal.

Cheers, Felix

On Tue, Dec 28, 2010 at 3:34 PM, Tim Hansen <address@hidden> wrote:

I had a working setup with an older version of paparazzi (svn checkout 2009-07) after migration to a newer version (git 2010-11-28) the radio doesn't work anymore. The aircraft is in auto2 all the time. I checked with an oscilloscope: The pulses arrive at the tiny. So it must be an software problem.

I tried to activate the ppm messages but the information in the wiki about this is outdated (old airframe config file).

Can someone tell me how they should be activated in the current version, or what might be the reason for the not working radio ?

I wish everybody a good start into next year

Paparazzi-devel mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]