[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] re: ir/actuators problem

From: Felix Ruess
Subject: Re: [Paparazzi-devel] re: ir/actuators problem
Date: Thu, 16 Dec 2010 17:43:48 +0100

When you have two paparazzi installations in different folders you
should make sure to set your environment variables correctly.

On Thu, Dec 16, 2010 at 5:25 PM, GARCIA ALVAREZ, ANA
<address@hidden> wrote:
> I was testing the PFD. First of all it was upside down. I had to change the
> ir-signs(which I don’t understand because they were ok in the previous
> software version). The attitude in the PFD was more or less ok, but the
> elevator didn’t move at any time, while the ailerons moved very little.
> In auto1 we could move the elevator via the RC control, but it didn’t move
> all alone.
> I don’t understand I only have problems with the new software and not the
> previous one. May it be because I have them two in the same laptop(different
> folders)?Or because I had an airspeed sensor connected with a mcu
> warning(the one which was corrected today)?
> (I could send the test log)
> Thanks
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden

reply via email to

[Prev in Thread] Current Thread [Next in Thread]