[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Servo jittering...

From: Gareth Roberts
Subject: Re: [Paparazzi-devel] Servo jittering...
Date: Mon, 06 Dec 2010 17:51:37 -0000
User-agent: Opera Mail/11.00 (Linux)

Is your RX connected and working (according to GCS)?
Otherwise it might put itself in AUTO1/AUTO2, both of which result in a bit of jitter (especially on the ground). Or outside interference? Try a single new servo - it could be a single dying servo in the xeno polluting the 5V supply.

On Mon, 06 Dec 2010 17:43:44 -0000, Volodymyr Khudyakov <address@hidden> wrote:

Hi gang...
Today I looking for very strange issue.
When I connect my TINY to all electronic components and switch ON, servos in
my Multiplex Xeno start jitter.
So, I successive disconnect electronics - Xbee, TV, ESC. Nothing, any
results - jittering.
Finally, I connect only AP, Rx and servos. Rx and servos powered form
separate battery. Nothing, any results - jittering.
I change AP...
Nothing, any results - jittering.
Who know, where is problem? Suggestions for next step?

Sincerely you

Paparazzi-devel mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]