RE: [Openexr-devel] use "" instead of <> for header?

[Nick Porcino]

Blender suffers from this as well. There were some complaints on their
mailing list about not being able to use OpenEXR "out of the box" when
building Blender.

I am hoping someone from the Blender team could provide us with more
information.

-----Original Message-----
From: address@hidden
[mailto:address@hidden On
Behalf Of Bob Friesenhahn
Sent: Tuesday, February 28, 2006 4:58 PM
To: E. Scott Larsen
Cc: OpenEXR devel list
Subject: Re: [Openexr-devel] use "" instead of <> for header?

On Sat, 25 Feb 2006, E. Scott Larsen wrote:
>
> This seems to support the same general consensus that Daniel and
Dennis 
> mention (and everyone I've talked to): use "" for references inside
the 
> current project, and use <> for references outside the current
project.
>
> I second the motion for this change.  The standard does seem to say
clearly 
> that switching to "" will do no harm, only good - and I do agree that
it will 
> make life easier for users.

Ditto.

Another factor to consider is that some users (possibly CinePaint) 
will sometimes want to use OpenEXR in an uninstalled mode so using an 
external config utility to obtain paths to use uninstalled OpenEXR 
will fail.

Bob
======================================
Bob Friesenhahn
address@hidden,
http://www.simplesystems.org/users/bfriesen/
GraphicsMagick Maintainer,    http://www.GraphicsMagick.org/


_______________________________________________
Openexr-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/openexr-devel