On 18 Mar 2015, at 10:37, Martin van Diemen <address@hidden> wrote:Hi,I want to monitor my network interfaces with monit.I've created the following basic config file:check network eth0 with interface eth0 if changed link then alertWhen reloading monit it would not load this config file:/etc/monit/conf.d/network:1: Error: syntax error 'eth0'I've different machines (all Ubuntu 14.04 LTS) different interfaces (eth0, eth1, lo) without any luck.According to the manual it should be that simple:http://mmonit.com/monit/documentation/monit.html#NETWORK-LINK-STATUS-TESTAny thoughts? Many Thanks!Martin --To unsubscribe:https://lists.nongnu.org/mailman/listinfo/monit-general