Re: [monit] Unable to Install Monit 5.0 Beta1

[Dave Paper]

Another thing that can sometimes bite you is running ./configure more  
than once w/o running 'make clean' and/or 'make distclean' in between  
runs.

Depending on the ./configure, it may write a configure cache file for  
use in the future.  This would be bad (and frustrating to uncover) if  
you change things on your system and want configure to pick it up, but  
it doesn't.

I don't know that the ./configure for monit has this problem, but it's  
not a bad habit to get into, IMNSHO. :)

-dave

On Jul 23, 2008, at 10:02 AM, John Timms wrote:

> Thanks, it worked perfectly. For others as dumb as myself, be sure  
> to use sudo before ./configure, make, and make install.
>
>
>
>
> On Wed, Jul 23, 2008 at 9:57 AM, Jan-Henrik Haukeland <address@hidden 
> > wrote:
>
> On 23. juli. 2008, at 15.19, John Timms wrote:
>
> error:
>   byacc -dt p.y
>   byacc: f - cannot open "y.tab.h"
>   make: *** [y.tab.c] Error 2
> uninstalled:
>   byacc
> installed:
>   btyacc
> used:
>   make
> error:
>   byacc -dt p.y
>   make: byacc: Command not found
>   make: *** [y.tab.c] Error 127
> uninstalled:
>   btyacc
> installed:
>   bison-1.35
> used:
>   make
> error:
>   byacc -dt p.y
>   make: byacc: Command not found
>   make: *** [y.tab.c] Error 127
> uninstalled:
>   bison-1.35
> installed:
>   bison
> used:
>   make
> error:
>   byacc -dt p.y
>   make: byacc: Command not found
>   make: *** [y.tab.c] Error 127
>
> Is anyone able to make sense of the problem?
>
> Ah, after bison was installed you also need to rerun monit's  
> configure to recreate the Makefile so it use bison instead of byacc.
>
>
>
>
> --
> To unsubscribe:
> http://lists.nongnu.org/mailman/listinfo/monit-general
>
>
>
>
> --
> To unsubscribe:
> http://lists.nongnu.org/mailman/listinfo/monit-general

--
Dave Paper                          address@hidden

"Hello, I must be going." --Groucho