[lwip-users] pin assignment on an ethernet module

[Pepe Prisas]

Hello there,

I have a Spartan-3 Starter Board with an ethernet module on one of the 
expansion ports and working with EDK 6.3.
My intention is to use the ethernet module on my project to be able to 
send/recieve TCP/IP frames using lwIP but I'm not quite sure how to map 
the pins of the ethernet module to the pins of the expansion port for 
the design to work.
How can this be done correctly?
It might be quite simple but I am quite a newbie on FPGA design so I 
would be very grateful for any help.

Thankyou very much,

Adrian.