Re: [Ltib] gdb error

[Ken Gilmer]

Joseph,

 Thanks for your attention.  In my case I'm running everything on my 
target system.  I'm not remote debugging from my host system.  From my 
understanding your suggestion would work if I was only running this from 
my host.  Please LMK if this is not the case.

Thanks again!
ken

Joseph E. Sacco, Ph.D. wrote:
> Ken,
>
> On the host end you need to set:
>
>    set solib-absolute-prefix  /a/b/c/d
>
> in order for the local system to find the shared libs that the target
> app was built against.
>
> Check out the gdb documentation on remote debugging.
>
>
> -Joseph
>
> =================================================================================
> On Thu, 2007-08-30 at 14:55 -0400, Ken Gilmer wrote:
>   
> > Hello,
> >
> >   I've compiled gdb for my target environment and am  trying to debug a 
> > program on my target device.  When I try to run a program from gdb I'm 
> > getting the following error:
> >
> > [Thread debugging using libthread_db enabled]
> > Error while reading shared library symbols:
> > Cannot find new threads: capability not available
> >
> >  Here is what gdb says when it starts:
> >
> > mx31# gdb
> > GNU gdb 6.4
> > Copyright 2005 Free Software Foundation, Inc.
> > GDB is free software, covered by the GNU General Public License, and you are
> > welcome to change it and/or distribute copies of it under certain 
> > conditions.
> > Type "show copying" to see the conditions.
> > There is absolutely no warranty for GDB.  Type "show warranty" for details.
> > This GDB was configured as "arm-none-linux-gnueabi".
> >
> >   Is this a problem with gdb or the program I'm trying to debug? 
> > TIA
> >
> > Ken
> >
> >
> > _______________________________________________
> > LTIB home page: http://bitshrine.org
> >
> > Ltib mailing list
> > address@hidden
> > http://lists.nongnu.org/mailman/listinfo/ltib
> >