[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Undefined control sequence. \embeddedps
From: |
n0oct |
Subject: |
Re: Undefined control sequence. \embeddedps |
Date: |
Thu, 17 Nov 2005 09:17:37 -0600 |
On Thu, 17 Nov 2005 14:54:42 +0100
Mats Bengtsson <address@hidden> wrote:
> That's only needed to process the documentation. You can safely change
> the line in configure.in that says
> STEPMAKE_PROGS(MAKEINFO, makeinfo, REQUIRED, 4.7)
> to read 4.6 instead and then run
> ./autogen
> to generate and run a new configure that accepts makeinfo 4.6.
I did this, and it still spits out the error that makeinfo needs to be
>= 4.7. Is there something I can edit by hand in configure?
> It may happen that when you run 'make' it will break at the end
> complaining about errors, but those will only affect the documentation
> and 'make install' should install everything else correctly so you can use
> the program.
>
> /Mats
--
72, Jim N0OCT
- Undefined control sequence. \embeddedps, jim smith, 2005/11/14
- Re: Undefined control sequence. \embeddedps, Mats Bengtsson, 2005/11/15
- Re: Undefined control sequence. \embeddedps, Jim Smith, 2005/11/15
- Re: Undefined control sequence. \embeddedps, Mats Bengtsson, 2005/11/15
- Message not available
- Message not available
- Re: Undefined control sequence. \embeddedps, n0oct, 2005/11/15
- Re: Undefined control sequence. \embeddedps, Mats Bengtsson, 2005/11/16
- Re: Undefined control sequence. \embeddedps, n0oct, 2005/11/17
- Re: Undefined control sequence. \embeddedps, Mats Bengtsson, 2005/11/17
- Re: Undefined control sequence. \embeddedps,
n0oct <=
- Re: Undefined control sequence. \embeddedps, Mats Bengtsson, 2005/11/17
- Re: Undefined control sequence. \embeddedps, n0oct, 2005/11/17