|
From: | Auto mailings of changes to Lily Issues |
Subject: | [Lilypond-auto] [LilyIssues-auto] [testlilyissues:issues] #4955 tie-configuration is partially ignored |
Date: | Sun, 14 Aug 2016 15:00:29 +0000 |
You can say that again.
lily/tie-formatting-problem.cc:1192
[...]
if (scm_is_pair (entry))
{
Tie_specification &spec = specifications_[k];
if (scm_is_number (scm_car (entry))) { spec.has_manual_position_ = true; spec.manual_position_ = scm_to_double (scm_car (entry)); /* TODO: check whether inexact? is an appropriate condition here */ spec.has_manual_delta_y_ = (scm_is_true (scm_inexact_p (scm_car (entry)))); } if (scm_is_number (scm_cdr (entry))) { spec.has_manual_dir_ = true; spec.manual_dir_ = Direction (scm_to_int (scm_cdr (entry))); } } k++;
So what is the deal with "has_manual_position" as opposed to "has_manual_delta_y" ?
The doc for the property just states:
(tie-configuration ,list? "List of @code{(@var{position} .
@var{dir})} pairs, indicating the desired tie configuration, where
@var{position} is the offset from the center of the staff in staff
space and @var{dir} indicates the direction of the tie (@code{1}=>up,
@address@hidden>down, @code{0}=>center). A non-pair entry
in the list causes the corresponding tie to be formatted
automatically.")
Obviously, somebody had a plan for something here.
[issues:#4955] tie-configuration is partially ignored
Status: New
Created: Fri Aug 12, 2016 07:29 AM UTC by Werner LEMBERG
Last Updated: Sun Aug 14, 2016 02:28 PM UTC
Owner: nobody
Attachments:
\version "2.19.46" \header { texidoc = " LilyPond should obey the vertical positions of ties as specified with @code{tie-configuration}. Here is a counterexample, where the positions of longer ties get changed. " } \paper { line-width = 80\mm } \relative { \override TieColumn.tie-configuration = #'((0 . 1) (2 . 1) (4 . 1)) <b'^~ d^~ f^~>1 | \break q | }
Sent from sourceforge.net because address@hidden is subscribed to https://sourceforge.net/p/testlilyissues/issues/
To unsubscribe from further messages, a project admin can change settings at https://sourceforge.net/p/testlilyissues/admin/issues/options. Or, if this is a mailing list, you can unsubscribe from the mailing list.
------------------------------------------------------------------------------ What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic patterns at an interface-level. Reveals which users, apps, and protocols are consuming the most bandwidth. Provides multi-vendor support for NetFlow, J-Flow, sFlow and other flows. Make informed decisions using capacity planning reports. http://sdm.link/zohodev2dev
_______________________________________________ Testlilyissues-auto mailing list address@hidden https://lists.sourceforge.net/lists/listinfo/testlilyissues-auto
[Prev in Thread] | Current Thread | [Next in Thread] |