[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Rearranging editor and command window panes in GUI

From: Doug Stewart
Subject: Re: Rearranging editor and command window panes in GUI
Date: Fri, 11 Jan 2019 19:53:58 -0500

On Fri, Jan 11, 2019 at 7:44 PM Andrew Janke <address@hidden> wrote:
Hi, folks,

Dumb question here.

I'm using the Qt GUI and I'm in the "Restore Default Window Layout"
mode. In this, the Command Window, Editor, and Documentation are three
tabs of a single panel, so you can see only one of them at once. Is
there a way to rearrange these tabs/panes so I can see both my Command
Window and Editor at the same time, without having to undock one of
them? I looked through the Octave documentation and I don't see anything
on this. (In fact, I don't see anything on the Qt GUI at all.)

Octave 4.4.1 on macOS 10.13.6.


Just grab the editor and move it a small amount, it will then find a new place to be.
you can have it north south east and west etc by where you let go of it 
DASCertificate for 206392

reply via email to

[Prev in Thread] Current Thread [Next in Thread]