[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Rearranging editor and command window panes in GUI

From: Torsten
Subject: Re: Rearranging editor and command window panes in GUI
Date: Sat, 12 Jan 2019 08:03:51 +0100

On 12.01.19 01:55, Andrew Janke wrote:
> On 1/11/19 7:53 PM, Doug Stewart wrote:
>> On Fri, Jan 11, 2019 at 7:44 PM Andrew Janke <address@hidden
>> <mailto:address@hidden>> wrote:
>>     Hi, folks,
>>     Dumb question here.
>>     I'm using the Qt GUI and I'm in the "Restore Default Window Layout"
>>     mode. In this, the Command Window, Editor, and Documentation are
>> three
>>     tabs of a single panel, so you can see only one of them at once. Is
>>     there a way to rearrange these tabs/panes so I can see both my
>> Command
>>     Window and Editor at the same time, without having to undock one of
>>     them? I looked through the Octave documentation and I don't see
>>     anything
>>     on this. (In fact, I don't see anything on the Qt GUI at all.)
>>     Octave 4.4.1 on macOS 10.13.6.
>>     Cheers,
>>     Andrew
>> Just grab the editor and move it a small amount, it will then find a
>> new place to be.
>> you can have it north south east and west etc by where you let go of it
>> -- 
>> DASCertificate for 206392
>> <>
> *Smacks forehead.* That worked. Thanks!

Just a small comment to your screenshot: The variable editor pane at the
right was not intended. In the upcoming new major release it will be
initially tabbed together with command, editor and doc widget.


reply via email to

[Prev in Thread] Current Thread [Next in Thread]