Re: Creating figures with Octave Plot

[Bob Odom]

Hi Francesco,

After I installed it on my SuSE 11.2 system, I found that some of the built-in 
epstk
demos worked and some did not. Specifically I would get an error that said 
something
like "eview: file not found." (I am not at that computer at the moment. I will 
send the
exact error message later.) It looked like eview was being called before the 
target
file was finished writing. I tried putting in a pause statement, which did not 
make
any difference, and I emailed the developer, but got no response.

Bob


On Thu, 4 Nov 2010, Francesco Potortì wrote:

> Answering a mail of September, 23:
>
> > I installed epstk for use with octave 3.2+ and couldn't get it to work, so
> > gave up. It worked fine with octave 3.0.2. My system is SuSE 11.2.
> > I sent an email to the developer, but got no response.
>
> Hm.  I just found the time to try one of my old epstk scripts, and it
> worked falwlessly.  I use Octave 3.2.4 and epstk 2.2 from a recent
> Debian distribution.
>
> Maybe Thomas Weber (the octave-epstk Debian maintainer) could be of some
> help, if you keep getting no feedback from epstk's author?
>
> --
> Francesco Potortì (ricercatore)        Voice: +39 050 315 3058 (op.2111)
> ISTI - Area della ricerca CNR          Fax:   +39 050 315 2040
> via G. Moruzzi 1, I-56124 Pisa         Email: address@hidden
> (entrance 20, 1st floor, room C71)     Web:   http://fly.isti.cnr.it/