help-octave
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Plotting


From: martin_helm
Subject: Re: Plotting
Date: Tue, 14 Apr 2009 02:23:07 -0700 (PDT)



asha g wrote:
> 
> 
> Thanks everyone for the help. I did add the hold on between both plots and
> got the desired result. Now did things change from Octave 3.0 to 3.03 as I
> could plot in Octave 3.0 without the hold in between the plots.
> Also, what if I have more than 2 plots. Where do I put the hold command?
> Asha 
> 
>> > 
>> > I am trying to plot two plots on the same plot :; 
>> > hold on 
>> > deltaT = 0.0035; niter = 10000; 
>> > t = linspace ( 0,deltaT*niter, niter)
>> > vv1 = vvvv(:,1);
>> > vvN = vvvv(:,N);
>> > 
>> > plot(t,vv1,'r*')
>> > plot(t,vvN,'b')
>> > 
>> > hold off
>> > 
>> > I am only getting one plot in blue but the legend says
>> vv1. 
>> > 
>> > I am using octave 3.03 in a Centos environment. 
>> > 
>> > Both vv1 and vvN are generating values that are
>> different and should thus
>> > plot. Could someone help me. 
>> > Thanks
>> > Asha 
>> > 
>> > 
>> >       Check out the all-new
>> Messenger 9.0! Go to
>> > http://in.messenger.yahoo.com/
>> > 
>> > _______________________________________________
>> > Help-octave mailing list
>> > address@hidden
>> > https://www-old.cae.wisc.edu/mailman/listinfo/help-octave
>> > 
>> > 
>> 
>> Simply add a "hold on" after the first and before the
>> second plot command.
>> 
>> - mh
>> 
>> -- 
>> View this message in context:
>> http://www.nabble.com/Plotting-tp23020319p23020941.html
>> Sent from the Octave - General mailing list archive at
>> Nabble.com.
>> 
>> _______________________________________________
>> Help-octave mailing list
>> address@hidden
>> https://www-old.cae.wisc.edu/mailman/listinfo/help-octave
>> 
> 
> 
>       Add more friends to your messenger and enjoy! Go to
> http://messenger.yahoo.com/invite/
> 
> _______________________________________________
> Help-octave mailing list
> address@hidden
> https://www-old.cae.wisc.edu/mailman/listinfo/help-octave
> 
> 

I checked again with 3.0.3 and you need a hold on before every further plot
command:

plot (...) 
hold on
plot(...)
hold on
plot(..)
hold on
plot(...)

and so on (somewhat ugly). With the development version 3.1.55 this is not
necessary. 
I could not check with 3.0.5 since I did not install it.

- mh

-- 
View this message in context: 
http://www.nabble.com/Plotting-tp23020319p23036071.html
Sent from the Octave - General mailing list archive at Nabble.com.



reply via email to

[Prev in Thread] Current Thread [Next in Thread]