Re: libpq.so

[Jeffrey G. Ubalde]

> The '[Echo cancelled]' message appeared in the cvs version some days
> ago. It means the cable reflected the transmission. The previous versions
> of gnokii just lost the sync and said 'fbus stream is out of sync...'.
> 
> > Message sent: 0x40 / 0x0004
> > 00 01 64 01                                     |   d
> > [Echo cancelled]
> > SM_Block Retry - 0
> > Message sent: 0x40 / 0x0004
> > 00 01 64 01                                     |   d
> > [Echo cancelled]
> > SM_Block Retry - 1
> > Message sent: 0x40 / 0x0004
> > 00 01 64 01                                     |   d
> > [Echo cancelled]
> 
> This part of the log shows gnokii gets back the message but there's no
> answer from the phone. Are you sure it is not an mbus cable? Try to
> add connection = m2bus into gnokiirc.
> 

Hi!

  I was using the same cable, same platform (redhat9), same cellphone, same 
version of gnokii and same gnokiirc..
and I compiled the same way I compiled gnokii on my machine.. but the error 
above still shows. 

I also tried your suggestion 'connection = m2bus' and this is what i got:

Serial device: opening device /dev/ttyS0
Serial device: setting speed to 9600
Serial device: setting RTS to high and DTR to low
Message sent: 0x40 / 0x0004
00 01 64 01                                     |   d
Serial device: setting RTS to low and DTR to low
Serial device: setting RTS to high and DTR to low
SM_Block Retry - 0
Message sent: 0x40 / 0x0004
00 01 64 01                                     |   d
Serial device: setting RTS to low and DTR to low
Serial device: setting RTS to high and DTR to low
The m2bus stream is out of sync - expected source=PHONE, got 1f
SM_Block Retry - 1
Message sent: 0x40 / 0x0004
00 01 64 01                                     |   d
Serial device: setting RTS to low and DTR to low
Serial device: setting RTS to high and DTR to low
Message sent: 0x40 / 0x0004
00 01 64 01                                     |   d
Serial device: setting RTS to low and DTR to low
Serial device: setting RTS to high and DTR to low
The m2bus stream is out of sync - expected source=PHONE, got 1f



Thanks again.... 
-jepoy