Re: Add supermicro PowerSupply to freeipmi please

[Al Chu]

> A bunch of x9dr7 and sc-826TQ works only for FRU addresses.

Does

ipmi-oem supermicro get-power-supply-status 1|2|3

work for the older ones?

Al

On 9/4/23 21:46, Андрей Грехов wrote:
> Hi.
> Понедельник,  4 сентября 2023, 22:27 +07:00 от "Al Chu" <chu11@llnl.gov>:
> > Hi,
> >
> > I believe this is already implemented via
> >
> > ipmi-oem supermicro get-pmbus-power-supply-status 1|2|3
> >
> > If you can confirm, I can document that it works on X9DRD too.
> I confirm.
> But it depends more on the type of case.
> Works for me on cs-825TQ.
> Which are connected by i1c connector "power 5 pin" and protocol PMBus
> (or old FRU)
>
> This should work from X8 to X11 "power 5 pin".
> I have X7DBE-X, but it works very unstable.
>
> A bunch of x9dr7 and sc-826TQ works only for FRU addresses.
> ipmitool -H $host -U $user -P $pass raw 0x06 0x52 0x05 0x$address 0x01 0x$d3
> $address = 70|72|74
>
> PWS-720-R
> $d3 :
> 0xA     Temp, C
> 0xB     Fan1, RPM=$izm*114,5
> 0xС     Fan2, RPM *114,5
> ----------
> There is no desire to add support for reading modern power supplies over the 
> PMBus (rev 1.0,1.1,1.2) ?
>
> > Al
> >
> > On 9/4/23 05:23, Андрей Грехов wrote:
> > > This working X9drd. PMBus rev.1.1-1.4
> > >
> > > ipmitool -H $host -U $user -P $pass raw 0x06 0x52 0x07 0x78 0x01 0x88
> > InputVoltage
> > > 0x78 first PowerSupply
> > > 0x7a second PowerSupply
> > > raw 0x06 0x52 0x07 0x78 0x01 0x90 Fan1
> > > raw 0x06 0x52 0x07 0x78 0x01 0x91 Fan2
> > >
> > > The's my old articl.
> > >
> > > Андрей Грехов
> > --
> > Al Chu
> > Livermore Computing
> > Lawrence Livermore National Laboratory
>
> Андрей Грехов

--
Al Chu
Livermore Computing
Lawrence Livermore National Laboratory