[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Emacs-diffs] Changes to emacs/INSTALL.CVS,v
From: |
Glenn Morris |
Subject: |
[Emacs-diffs] Changes to emacs/INSTALL.CVS,v |
Date: |
Sun, 08 Jun 2008 19:00:39 +0000 |
CVSROOT: /sources/emacs
Module name: emacs
Changes by: Glenn Morris <gm> 08/06/08 19:00:39
Index: INSTALL.CVS
===================================================================
RCS file: /sources/emacs/emacs/INSTALL.CVS,v
retrieving revision 1.20
retrieving revision 1.21
diff -u -b -r1.20 -r1.21
--- INSTALL.CVS 8 Jun 2008 11:40:45 -0000 1.20
+++ INSTALL.CVS 8 Jun 2008 19:00:38 -0000 1.21
@@ -10,7 +10,7 @@
Therefore, to build from CVS you must run "make bootstrap"
instead of just "make":
- $ cvs update
+ $ cvs update -dP
$ ./configure
$ make bootstrap
@@ -22,15 +22,6 @@
file gets into a bad state due to changes in the Lisp libraries; this procedure
forces it to be regenerated.)
-If even 'make bootstrap' followed by 'make maintainer-clean' fails, it may
-be that some reorganization of the tree has created a new subdirectory. Try
-this:
-
- $ cvs update -d
- $ make maintainer-clean
- $ ./configure
- $ make bootstrap
-
Normally, it is not necessary to use "make bootstrap" after every CVS
update. Unless there are problems, we suggest using the following
alternative procedure after you have done "make bootstrap" at least
- [Emacs-diffs] Changes to emacs/INSTALL.CVS,v, Eric S. Raymond, 2008/06/08
- [Emacs-diffs] Changes to emacs/INSTALL.CVS,v, Bastien Guerry, 2008/06/08
- [Emacs-diffs] Changes to emacs/INSTALL.CVS,v,
Glenn Morris <=
- [Emacs-diffs] Changes to emacs/INSTALL.CVS,v, Glenn Morris, 2008/06/08
- [Emacs-diffs] Changes to emacs/INSTALL.CVS,v, Alan Mackenzie, 2008/06/09
- [Emacs-diffs] Changes to emacs/INSTALL.CVS,v, Glenn Morris, 2008/06/09
- [Emacs-diffs] Changes to emacs/INSTALL.CVS,v, Glenn Morris, 2008/06/17
- [Emacs-diffs] Changes to emacs/INSTALL.CVS,v, Stefan Monnier, 2008/06/20