[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Emacs-diffs] Changes to emacs/INSTALL.CVS,v
From: |
Eric S. Raymond |
Subject: |
[Emacs-diffs] Changes to emacs/INSTALL.CVS,v |
Date: |
Sun, 08 Jun 2008 11:33:13 +0000 |
CVSROOT: /sources/emacs
Module name: emacs
Changes by: Eric S. Raymond <esr> 08/06/08 11:33:11
Index: INSTALL.CVS
===================================================================
RCS file: /sources/emacs/emacs/INSTALL.CVS,v
retrieving revision 1.18
retrieving revision 1.19
diff -u -b -r1.18 -r1.19
--- INSTALL.CVS 7 May 2008 07:35:40 -0000 1.18
+++ INSTALL.CVS 8 Jun 2008 11:33:11 -0000 1.19
@@ -10,6 +10,7 @@
Therefore, to build from CVS you must run "make bootstrap"
instead of just "make":
+ $ cvs update
$ ./configure
$ make bootstrap
@@ -21,6 +22,15 @@
file gets into a bad state due to changes in the Lisp libraries; this procedure
forces it to be regenerated.)
+If even 'make bootstrap' followed by 'make maintainer-clean' fails, it may
+be that some reorganization of the tree has created a new subdirectory. Try
+this:
+
+ $ cvs -d update
+ $ make maintainer-clean
+ $ ./configure
+ $ make bootstrap
+
Normally, it is not necessary to use "make bootstrap" after every CVS
update. Unless there are problems, we suggest using the following
alternative procedure after you have done "make bootstrap" at least
- [Emacs-diffs] Changes to emacs/INSTALL.CVS,v,
Eric S. Raymond <=
- [Emacs-diffs] Changes to emacs/INSTALL.CVS,v, Bastien Guerry, 2008/06/08
- [Emacs-diffs] Changes to emacs/INSTALL.CVS,v, Glenn Morris, 2008/06/08
- [Emacs-diffs] Changes to emacs/INSTALL.CVS,v, Glenn Morris, 2008/06/08
- [Emacs-diffs] Changes to emacs/INSTALL.CVS,v, Alan Mackenzie, 2008/06/09
- [Emacs-diffs] Changes to emacs/INSTALL.CVS,v, Glenn Morris, 2008/06/09
- [Emacs-diffs] Changes to emacs/INSTALL.CVS,v, Glenn Morris, 2008/06/17
- [Emacs-diffs] Changes to emacs/INSTALL.CVS,v, Stefan Monnier, 2008/06/20