Re: [Denemo-devel] Built 0.8.4 for Jack under Debian Lenny. Now what?

[Nils Gey]

You only were on IRC for a few minutes. I'm actually there now.
But in short: You have to activate the bridge in your qjackctl setup: Config -> 
first tab, lower left corner switch Midi Driver to "Seq"

Nils

On Fri, 15 May 2009 20:50:10 +0100
Richard Shann <address@hidden> wrote:

> I have just tried the sequence start qjackctl, then start denemo and
> denemo appears in the MIDI tab of the connections panel of qjackctl,
> while my MIDI controller is in the ALSA tab along with timidity - which
> I can connect the MIDI controller to. What I want to do is connect the
> MIDI controller to Denemo.
> But I can't connect across tabs, can I?
> Richard
> 
> 
> On Fri, 2009-05-15 at 18:59 +0100, Richard Shann wrote:
> > On Fri, 2009-05-15 at 12:49 -0500, Jeremiah Benham wrote:
> > > > and
> > > > libasound2-dev package.
> > > > On startup denemo now gives some new error messages:
> > > >
> > > 
> > > Did you compile --with-jack in addition. I don't know if lash works  
> > > without jack. AFAIK jack also needs to either running at startup or  
> > > needs to launched by denemo at startup.
> > 
> > Yes, I did both (I was going by what Nils put on denemo.org download
> > page). (actually it was --enable-jack --enable-lash is --with a synonym
> > for --enable?)
> > I have started denemo after starting qjackctl and get that message...
> > Richard
> > 
> > 
> > 
> > 
> > _______________________________________________
> > Denemo-devel mailing list
> > address@hidden
> > http://lists.gnu.org/mailman/listinfo/denemo-devel
> 
> 
> 
> _______________________________________________
> Denemo-devel mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/denemo-devel
> 


-- 
Nils Gey <address@hidden>