Re: SELinux enabled despite --without-selinux?

[Bernhard Voelker]

On 01/21/2014 11:17 AM, Pádraig Brady wrote:
> On 01/21/2014 09:24 AM, Bernhard Voelker wrote:
>> In a git working tree (v8.22-15-g9a115f3):
>>
>>   $ git clean -xdfq
>>   $ ./bootstrap
>>   ...
>>   $ ./configure --quiet --without-selinux
>>   configure: WARNING: SELinux enabled, but matchpathcon_init_prefix not found
>>   configure: WARNING: The install utility may run slowly
>>   config.status: creating po/POTFILES
>>   config.status: creating po/Makefile
>>
>> Why is "SELinux enabled" although requested otherwise?
> 
> It's not really enabled I think and that's just an erroneous warning.

yes, you're right, thanks.

> Does the attached suppress it?

Almost:

  ./configure: line 59762: syntax error near unexpected token `fi'
  ./configure: line 59762: `      fi'

You need:

  -      if test "$with_selinux" != no
  +      if test "$with_selinux" != no; then

With that, it works, i.e. the bogus warning disappears.

Thanks & have a nice day,
Berny