Re: [avr-gcc-list] end of tool chain (programming)

[joe]

Eric,
I use the stk500 with avr-gcc almost daily.  No problems and the board is
great for prototyping.  I followed the steps at AVRFreaks(
http://www.avrfreaks.com/AVRGCC/index.php ) and use it with Atmels AVRStudio
as the IDE, no problems with programming via the serial port at all.  The
whole setup was extremely easy to set up if you take the time to read the
docs on setting up the two to run together(also available on the AVRFreaks
web site: http://www.avrfreaks.com/Tools/ToolFiles/228/avrgcc_studio.pdf ).
Getting AvrX to compile was a little tricky, but not bad.

Hope that helps.
Joe

----- Original Message -----
From: "Eric Fort" <address@hidden>
To: <address@hidden>
Sent: 2002 Mar 22 1:07 PM
Subject: [avr-gcc-list] end of tool chain (programming)


> I looked at the gnu (avr-gcc) toolchain an it appears
> to leave off with the hex file to be
> programmed/uploaded.  Could someone please suggest
> some currently available programming options?  I've
> been looking at the stk500 but there seems to be
> problems in using it under the free tools (atmel seems
> lazy about releasing the protocol to drive it.
>
> Thanks,
>
> Eric
>
> __________________________________________________
> Do You Yahoo!?
> Yahoo! Movies - coverage of the 74th Academy Awards®
> http://movies.yahoo.com/
> avr-gcc-list at http://avr1.org
>

avr-gcc-list at http://avr1.org