Re: [avr-gcc-list] end of tool chain (programming)

[Eric Fort]

I'm looking to use this under linux without
avr-studio.  any ideas?  I'm thinking that it's
avrstudio that accually downloads/programs the device
in this case.

Thanks for the help,

Eric


--- address@hidden wrote:
> Eric,
> I use the stk500 with avr-gcc almost daily.  No
> problems and the board is
> great for prototyping.  I followed the steps at
> AVRFreaks(
> http://www.avrfreaks.com/AVRGCC/index.php ) and use
> it with Atmels AVRStudio
> as the IDE, no problems with programming via the
> serial port at all.  The
> whole setup was extremely easy to set up if you take
> the time to read the
> docs on setting up the two to run together(also
> available on the AVRFreaks
> web site:
>
http://www.avrfreaks.com/Tools/ToolFiles/228/avrgcc_studio.pdf
> ).
> Getting AvrX to compile was a little tricky, but not
> bad.
> 
> Hope that helps.
> Joe
> 
> ----- Original Message -----
> From: "Eric Fort" <address@hidden>
> To: <address@hidden>
> Sent: 2002 Mar 22 1:07 PM
> Subject: [avr-gcc-list] end of tool chain
> (programming)
> 
> 
> > I looked at the gnu (avr-gcc) toolchain an it
> appears
> > to leave off with the hex file to be
> > programmed/uploaded.  Could someone please suggest
> > some currently available programming options? 
> I've
> > been looking at the stk500 but there seems to be
> > problems in using it under the free tools (atmel
> seems
> > lazy about releasing the protocol to drive it.
> >
> > Thanks,
> >
> > Eric
> >
> > __________________________________________________
> > Do You Yahoo!?
> > Yahoo! Movies - coverage of the 74th Academy
> Awards®
> > http://movies.yahoo.com/
> > avr-gcc-list at http://avr1.org
> >
> 


__________________________________________________
Do You Yahoo!?
Yahoo! Movies - coverage of the 74th Academy Awards®
http://movies.yahoo.com/
avr-gcc-list at http://avr1.org