[Help-gnu-radius] Cisco VSA AV-Pair Attribute Issue

[Lewis Watson]

I wanted to provide some more information to try and have gnu radius pass
Cisco-AV-Pair tx-modem-speed to the accounting table. Accounting log looks
like this....

 Acct-Status-Type = Stop
        Acct-Authentic = RADIUS
        Service-Type = Framed-User
        Acct-Session-Id = 00001448
        Framed-Protocol = PPP
        Framed-IP-Address = 65.202.119.122
        Acct-Terminate-Cause = User-Request
        Acct-Input-Octets = 370806
        Acct-Output-Octets = 1863375
        Acct-Input-Packets = 3668
        Acct-Output-Packets = 4015
        Acct-Session-Time = 1817
        Cisco-AVPair = disc-cause-ext=1045
        Cisco-AVPair = pre-bytes-in=175
        Cisco-AVPair = pre-bytes-out=145
        Cisco-AVPair = pre-paks-in=7
        Cisco-AVPair = pre-paks-out=6
        Cisco-AVPair = pre-session-time=3100001
        Cisco-AVPair = connect-progress=60
        Cisco-AVPair = nas-rx-speed=21600
        Cisco-AVPair = nas-tx-speed=26400
        Acct-Delay-Time = 0
        Hint = single
        Simultaneous-Use = 1


Current dictionary file... looks like
VENDOR          Cisco           9
#
#       Standard attribute
#
ATTRIBUTE       Cisco-AVPair            1       string          Cisco
ATTRIBUTE       Cisco-PRI-Circuit       2       string          Cisco
ATTRIBUTE       nas-tx-speed    26      string  Cisco

Here is the stop query...
acct_stop_query      UPDATE calls \
                     SET status=%C{Acct-Status-Type},\
                         acct_session_time=%C{Acct-Session-Time},\
                         acct_input_octets=%C{Acct-Input-Octets},\
                         acct_output_octets=%C{Acct-Output-Octets},\
                         connect_term_reason=%C{Acct-Terminate-Cause},\
                        connect_speed='%C{nas-tx-speed}' \
                        WHERE user_name='%C{User-Name}' \
                       AND status = 1 \
                       AND acct_session_id='%C{Acct-Session-Id}'

In the logs I am not seeing any issue regarding "unknown attribute" after
editing it as shown above but we still do not get a value for
nas-tx-speed... Any ideas?
Thanks!
Lewis